This is an awning operator of aluminum diecast construction with a gray baked enamel finish used on Stanley Windows. It is left-handed with a matching crank handle and 2-3/16 in. offset link arm. It has an L-shaped mounting hole pattern that has 2 holes 7/16 in. apart at the top and is 5-1/4 in. from the center of the top holes to the center of the bottom hole and the 2 horizontal holes in the bottom leg are 1-1/2 in. on center.

This is an awning operator of aluminum diecast construction with a gray baked enamel finish used on Miami windows. It is right-handed with a matching crank handle with a 2-3/16 in. offset link arm. It has an L-shaped mounting hole pattern with one hole offset on the straight edge. The mounting holes are 5-1/8 in. from the center of the top hole to the center of the bottom hole and the 2 horizontal holes in the bottom leg are 1-1/2 in. on the center.

This is an awning operator of aluminum diecast construction with a gray baked enamel finish used on Stanley-C and E Windows. It is right-handed with a matching crank handle with a 2-3/16 in. link arm. It has an L-shaped mounting hole pattern that is 5-1/4 in. from the center of the top hole to the center of the bottom hole and the 2 horizontal holes in the bottom leg are 1-3/8 in. on the center.

This is an awning operator of aluminum diecast construction with a gray baked enamel finish used on Pan-American Windows. It is left-handed with a matching crank handle with a 2-5/8 in. link arm. It has an L-shaped mounting hole pattern that has two top holes that are 5-1/4 in. from the center of the top holes to the center of the bottom hole and the two horizontal holes in the bottom leg are 1-5/16 in. on the center.

This is an awning operator of aluminum diecast construction with a gray baked enamel finish used on Air Control-Keller Windows. It is right-handed with a matching crank handle with a 2-3/8 in. link arm. It has an L-shaped mounting hole pattern that is 5-1/4 inches from the center of the top hole to the center of the bottom hole and the two horizontal holes in the bottom leg are 1-1/8 in. on the center.

This jalousie operator by Prime-Line Products is constructed of aluminum components and comes in a milled aluminum finish. It is a right-handed slim-line design that mounts to jalousie windows, to open and close jalousie glass slats with a single up or down maneuver. It has a 2-7/8 in. link arm with a 5/16 in. stud on the end of the arm that connects to the louvers with an E ring. It has mounting holes 4-13/16 in. on the center.