Light Blue Transitional Modern Switch Plates

To make a wall plate, two pieces of glass are cut, cleaned, stacked together and placed into a kiln. The kiln goes up to 1450°f, the glass becomes molten and fuses together to make one piece of glass. The glass goes to a water jet and the plate is cut out. Then, the glass is placed onto a mold and taken to 1300°f, the glass becomes elastic and gravity pulls the glass over the mold. Hot knobs call this process slumping. The glass spends about 48 hours in the kilns. Expect slight variations in color and size.

Just what I need and it's very classy.. Marion. Riverside, CA. Fri Oct 05 2018

Printed stainless steel metal plate with screws only. (Electrical Components are not included) Plates are printed with 3 layers of hard ink with UV treatment.

Printed stainless steel metal plate with screws only. (Electrical Components are not included) Plates are printed with 3 layers of hard ink with UV treatment.

Well made and sturdy. Dawn. Los Angeles, CA. Sat Aug 05 2023

Printed stainless steel metal plate with screws only. (Electrical Components are not included) Plates are printed with 3 layers of hard ink with UV treatment.

The colors were not a vibrant as I wanted.. Leah. Fredericksburg, VA. Fri Dec 13 2024

Printed stainless steel metal plate with screws only. (Electrical Components are not included) Plates are printed with 3 layers of hard ink with UV treatment.