Show Related CategoriesCategory
Commercial Exterior Lighting
to:Â

By AeternaSol
FREE Delivery
"This 200W bifacial monocrystalline solar panel uses N-Type cells with 18BB full welding silver containing busbars and cell efficiency of up to 25 percent, providing steady output for off-grid power systems. The 18BB layout limits micro cracks and internal power loss, supporting low degradation of no more than 1 percent in the first year and 0.4 percent per year thereafter. An IP68 rated potted junction box keeps water and moisture from reaching internal wiring, and its thermally conductive construction helps dissipate heat. The panel uses 11 AWG oxygen-free copper wire rated for up to 25A with a UV resistant outer jacket, plus a standard MC5 connector with galvanized copper pins in a PPO shell. A corrosion resistant aluminum alloy frame with applied sealant protects the cells, and pre-drilled holes support straightforward mounting. The transparent backsheet allows the bifacial cells to collect sunlight from both sides, including reflected and diffused light from surfaces such as grass, sand, awnings and rooftops, which increases energy harvest where reflected light is available. Use it to charge an external battery bank and supply power for RVs, camping, cabins and other off-grid setups.

By AeternaSol
FREE Delivery
This 200W bifacial monocrystalline solar panel uses N-Type solar cells with 18BB silver busbars and an EL-tested cell conversion rate of up to 25.6 percent, providing steady output for off-grid power systems. The bifacial construction collects light from both surfaces, and the 18BB layout helps limit hot spots and micro cracks that reduce long term performance. A thermal conductive silicone filled junction box carries an IP68 rating for dust and water protection, while the corrosion resistant aluminum frame is tested to 2400Pa wind pressure and 5400Pa snow load for permanent outdoor mounting. Pre-drilled holes accept Z brackets, angle brackets and pole mounts, and standard MC4 connectors allow plug and play wiring when you add more panels later. Install it on an RV, caravan, boat, camper, shed, cabin or home rooftop to charge batteries and support backup power for lighting, electronics and small appliances. The panel is covered by a 10-year full product warranty and a 25-year power output warranty of 95 percent at 5 years, 90 percent at 10 years and 80 percent at 25 years, with technical support available for installation and product questions.

By AeternaSol
FREE Delivery
This 100 watt N-Type monocrystalline solar panel is a compact 12 volt charging solution for Class B vans, small campers, boats, sheds, and remote battery banks. Grade A cells with 18 busbars reach 25 percent efficiency and deliver 22.89 volts and 4.37 amps at maximum power, with first year degradation rated at 1 percent or less and 0.4 percent annually over a 25 year service life. The panel measures 39.76 by 18.11 by 1.18 inches, using 3.2 millimeter low iron tempered glass and a 1.2 millimeter corrosion resistant aluminum frame that handle 2400 Pa wind pressure and 5400 Pa snow loads. A potting sealed IP68 junction box with a built-in blocking diode helps limit reverse current after dark, and 11AWG pure copper cable rated for 25 amps ends in standard MC4 connectors. Pre-drilled holes and plug-in wiring make installation a short job with common Z brackets, and the panel works with 12 volt MPPT or PWM controllers.

By AeternaSol
FREE Delivery
This 100W monocrystalline solar panel uses N-Type 18BB solar cells with cell efficiency of up to 25 percent, delivering dependable output for off-grid power systems. The 18BB busbar design reduces internal resistance and limits micro cracks, supporting low power degradation of no more than 1 percent in the first year and 0.4 percent per year thereafter. IP68 rated sealing protects internal components from water, dust and moisture, and the weather resistant construction supports reliable outdoor use. The panel works with 12V MPPT or PWM charge controllers and portable power stations, making it suitable for Class B vans, RVs, campers, boats and cabins. Pre-drilled mounting holes work with compatible brackets for straightforward installation, and standard MC4 connectors allow simple wiring and system expansion when additional panels are added later. Use it with a charge controller and an external battery bank to supply power for lighting, electronics and small appliances away from grid connections.

By AeternaSol
FREE Delivery
This 225 watt HPBC solar panel uses a zero busbar cell design that removes the front grid lines found on conventional modules, so more of the panel surface collects light and output holds up better when shade crosses part of the array. The back contact cell structure and full welding process support steady performance in low light, making the panel a practical choice for RV roofs, camper vans, boat decks, cabins, sheds, and off-grid battery banks running on 12 volt systems. Grade A monocrystalline cells sit under reinforced tempered glass with a corrosion resistant aluminum frame, and an IP68 rated junction box with pre-installed MC4 connectors keeps wiring simple. At 53.3 by 30.2 by 1.2 inches and about 26.5 pounds, it fits compact roof spaces without adding excess weight. The panel works with MPPT or PWM charge controllers and is built for outdoor use in dust, rain, and salt air.

By AeternaSol
FREE Delivery
This 200 watt black frame N-Type solar panel is built for 24 volt battery banks, delivering 30.6 volts and 6.54 amps at maximum power with cell efficiency up to 25.6 percent. Its 16 busbar construction and four independent module circuits keep output flowing when part of the panel is shaded by a roof vent, railing, or tree branch, while anti-reflective glass, EVA encapsulation, and a waterproof backsheet protect the cells in demanding weather. The IP68 rated junction box and connectors are engineered for a working range of minus 45 to plus 85 degrees Celsius, and the corrosion resistant aluminum frame measures 49.69 by 30.08 inches at about 21 pounds per panel. A built-in blocking diode helps limit reverse current after dark, and standard MC4 connectors plug into common charge controllers without adapters. It suits Class B vans, cabins, marine setups, and 12 volt or 24 volt off-grid systems.

By AeternaSol
FREE Delivery
"This 200W bifacial monocrystalline solar panel uses N-Type cells with 18BB full welding silver containing busbars and cell efficiency of up to 25 percent, providing steady output for off-grid power systems. The 18BB layout limits micro cracks and internal power loss, supporting low degradation of no more than 1 percent in the first year and 0.4 percent per year thereafter. An IP68 rated potted junction box keeps water and moisture from reaching internal wiring, and its thermally conductive construction helps dissipate heat. The panel uses 11 AWG oxygen-free copper wire rated for up to 25A with a UV resistant outer jacket, plus a standard MC4 connector with galvanized copper pins in a PPO shell. A corrosion resistant aluminum alloy frame with applied sealant protects the cells, and pre-drilled holes support straightforward mounting. The transparent backsheet allows the bifacial cells to collect sunlight from both sides, including reflected and diffused light from surfaces such as grass, sand, awnings and rooftops, which increases energy harvest where reflected light is available. Use it to charge an external battery bank and supply power for RVs, camping, cabins and other off-grid setups.

By AeternaSol
FREE Delivery
"This 100 watt solar panel uses grade A N-Type cells with 18 busbar silver-containing full welding technology, reaching up to 25 percent cell efficiency and offering a longer service life than conventional 10 and 12 busbar designs. Each cell is EL tested before assembly for consistent output in RVs, cabins, boats, sheds, and home backup systems. A built-in reverse current blocking diode helps keep stored battery power from flowing back through the panel after dark. The polyurethane-filled junction box is rated IP68 against dust and water, and the corrosion-resistant aluminum alloy frame is engineered for 2400 Pa wind pressure and 5400 Pa snow loads in exposed outdoor locations. Standard MC4 connectors with copper contacts and heat-resistant PPO housing reduce resistance and heat buildup at the connection point, plugging in directly without adapters for a straightforward installation.

By AeternaSol
FREE Delivery
This 200 watt black frame N-Type monocrystalline solar panel delivers 23.04 volts and 8.68 amps at maximum power, making it a practical single panel building block for 12 volt RV roofs, boat decks, cabins, camping setups, and off-grid battery banks. Grade A cells with 18 silver-containing full welding busbars reach 25 percent cell efficiency, reduce heat generation, and hold output better when part of the panel is shaded by a vent or railing. The module measures 52.8 by 26.4 by 1.2 inches and combines 3.2 millimeter low iron tempered glass with a 1.2 millimeter corrosion resistant aluminum frame that withstands 2400 Pa wind pressure and 5400 Pa snow loads. A potting sealed IP68 junction box with a built-in blocking diode helps limit reverse current after dark, while thicker MC4 connectors and 11AWG oxygen free copper cable keep resistance low in all weather. The black finish blends with dark roof surfaces, and the series is rated for a 25 year service life with low annual degradation.

By AeternaSol
FREE Delivery
This 400 watt solar kit brings together four 100 watt N-Type monocrystalline panels, giving a 12 volt system room to grow across a large van roof, cabin, workshop, or off-grid battery bank. Grade A cells with 18 busbars reach 25 percent efficiency, and each panel delivers 22.89 volts and 4.37 amps at maximum power with low degradation rated over a 25 year service life. At 39.76 by 18.11 inches each, the four modules can be arranged in separate roof zones or combined into one array, while 3.2 millimeter low iron tempered glass and 1.2 millimeter corrosion resistant aluminum frames handle 2400 Pa wind pressure and 5400 Pa snow loads. Potting sealed IP68 junction boxes with built-in blocking diodes help limit reverse current after dark. Standard MC4 connectors, 11AWG pure copper cable rated for 25 amps, and pre-drilled frames support fast wiring to 12 volt MPPT or PWM controllers, and the layout scales toward larger 800 watt and 1600 watt arrays.

By AeternaSol
FREE Delivery
Salt air punishes hardware, and a boat deck is a hard place for anything that was not built for it. This hundred-watt panel uses an electroplated aluminum frame with reinforced corners that resists the corrosion which turns ordinary mounts chalky within a season. The N-type cell stack reads low-angle light well, so it starts producing earlier in the morning and keeps going into the evening, which matters when a bilge pump and a fridge are drawing overnight. Built-in drainage holes shed spray instead of trapping it. Sized for bimini tops, radar arches, and small trawler cabins.