|Newport Simple Platform Bed||14" H x 43 - 78" W x 79 - 88" D||87 - 138 lbs|
|Nevis 1 Drawer Nightstand||26" H x 23" W x 19" D||48 lbs|
|Nevis 5 Drawer Chest||56" H x 32" W x 19" D||143 lbs|
|Nevis Espresso 7 Drawer Dresser||34" H x 63" W x 19" D||161 lbs|
|Nevis Armoire||71" H x 37" W x 24" D||240 lbs.|
|Nevis TV Stand||44" H x 55" W x 22" D||176 lbs|
|Product Category:||Bedroom Sets|
Questions & Answers (3)
“Hi, what is the height from the bottom the frame to the floor?” asked by Jen
“Hi, does this bed frame require a box spring?” asked by Joanie
“How does this bed compare to the Mercury Row Apollo Platform bed? The only difference I can identify is the height of the bed. Is the color of the Newport Simple bed darker than the espresso color of the Apollo?” asked by Alex
Modus Newport Simple Platform Bedroom Collection
Great quality for the price
Peter from Minneapolis, MN– Verified Buyer
The price was right on this bed frame. At the same time we were a little concerned that the quality wouldn't be that great. We were pleasantly surprised. It was easily put together by one person. Once we had the frame in place with the mattress on it it was extremely stable and solid. It makes zero noise when you jump on or move while on the mattress. To be perfectly frank, my wife and I tend to give our beds a pretty good work out and this bed frame is not phased in the least bit.
Great bed frame
Paul from Carol Stream, IL– Verified Buyer
We really like this bed frame but I wanted to post some correct measurements. The bottom of the side rails sit 8 inches above the floor and it is 5.5 inches wide, so the top is 13.5 inches from the floor. In the Q&A they state that the mattress sits 4 inches into the frame, but it is really only 2.5 inches. This was a big concern for us because we were worried that 4 inches would make the bed too short and also difficult to get the sheet onto the mattress. We actually wanted it even taller (I'm 6'5") so we were able to put the side rails on upside down so that the slats sit toward the top of the side rail instead of toward the bottom. This puts the top of the slats just 0.5 inch below the top of the side rail at about 13 inches off the floor. With our 13 inch mattress that put our bed height at 26 inches which is just what we wanted. There are 4 center legs that have a height adjustment and we were able to adjust them all the way up to make them work with this arrangement. I may replace them later (they are just stained 2X2's) for aesthetics if we get tired of seeing the feet extended all they way down, but you usually can't see them unless you are on the floor.
A good quality product
David Jones from Charleston, SC– Verified Buyer
I purchased a great mattress on sale that I wanted to pair with a decent bed. However, I move frequently and wanted a bed that had a bit of portability (something that would be easy to put-up and break down) and also decent quality. This is an outstanding bed for what I wanted. Set-up time for me was about an hour from unpacking to putting the mattress on it. Simply laid-out the parts on the floor, connect the corners posts with screws and put the slats on. Given that I'd be breaking the bed down in about 8 months I didn't use screws for all the slats, only those slats on the end were screwed in. The webbing that connected the slats equally space them out and the weight of the mattress would hold them in place; thus, no need to screw them all in. I attached the support piece that runs down the middle of the bed only at the end slats. Again the weight of the mattress holds it in place. About 16 to 18 screws total holds everything together. The bed doesn't rock or creak and looks great. I'm very happy with this purchase and would recommend this bed to people who would want a quality bed for less than $150.
Very nice for the price!
Quality Seeker from San Diego, CA
Just a couple of tips for future buyers. Most importantly, do not tighten any of the screws during preliminary set up. The frame does only come with enough screws for every other slat so I purchased another dozen and I did not tighten the slat screws until AFTER aligning the corners nice and even and tightening. I think that if you tighten the slat screws as you put each one in that it may seem like the holes will not all line up and it may disallow the corners to have an even appearance. So just put them in about a third before tightening them at the very end. My queen set also came with 4 support legs (unlike description)and I thought that was great. It appears to be very sturdy and I had an easy time putting it together (and I'm a girl!)I do recommend an electric screw driver for the slat screws to save your wrists.
Robert from Zionsville, IN– Verified Buyer
This is a solid wood frame - not those composite fake wood furniture in this and even higher price points. This is queen size for our elderly mother and we already had two twins in our own home so I knew I could count on the quality construction. Slats are close together and secured to both the side rails and the center support. We have the espresso which is rich color stain and it goes really well with a queen bamboo headboard in a medium natural shade (just leaning against the wall) - like one would see in the tropics. These are must-have beds that should last a lifetime. Be careful that the instructions are a little confusing as to which "numbered" holes to install the various screws into when building the center rail section - be sure NOT to insert the 4 legs of the center support into the holes that have the brass nuts underneath the center rail. Those 4 holes are for the slats that you install onto the center rail later. Therefore they need to improve the accuracy of the instructions lest you install screws in the wrong places in the center rail.
Great Bed frame for memory foam mattress
A_K from Keller, TX– Verified Buyer
My husband and I bought this bed frame for our master bedroom about 5 weeks ago and have been using it for approximately 3 weeks (took about 2 weeks from the day we ordered to the day we received it). Once it arrived we had to get it off the truck but it was in several boxes so they were easy to handle. We purchased the king in espresso finish and it looks very nice. It works great with our memory foam mattress. The bed seems very sturdy so far and doesn't creak or make any noises at all. It was fairly easy to put together with 2 people (just had to adjust the screws for the outside supports to make it the correct width for the slats to line up with the appropriate holes on each side). It works well and is just the right height with our 14 mattress (sits at approximately 24 inches high with the mattress). The only thing I didn't appreciate was the delivery truck service was a little rude on the phone when I called to get status updates on shipment. I'm still giving this a 55 because overall we are very happy with this product!
Robert from Zionsville, IN– Verified Buyer
These need to be assembled but it was not difficult if you have enough space to move the pieces around without bumping into other things. They are really beautiful - finish (espresso) and solid wood, high quality. Very sturdy even for large adult. Value was excellent and price quite affordable because buying all the parts for new beds can add up with linens, mattresses and beds. Also - we looked for months to find twin beds that would look nice in a guest bedroom for adults - most twin bed frames are for kids and poorly constructed and have no sophistication in design. Also even very expensive bed frames (thousand or higher) often are not in twin sizes so shopping was frustrating. These were PERFECT!
Great quality for the money
Andrew from South Portland, ME– Verified Buyer
This bed is real, solid wood and very sturdy. It's a dark espresso color that almost looks black unless it's in direct sunlight. I've had this bed for over a year now and it still feels as solid as the day I put it together. The slats in the center are perfect for use with a foam mattress. Very happy with my purchase and will buy another when I need one for a second bedroom.
Looks great and fits our exact needs
Quang from Minneapolis, MN– Verified Buyer
We ordered this bed after we renovated our upstairs into a master suite and wanted a king sized bed. We were looking for a platform bed that looked nice and would fit our style. We wanted an upholstered bed but with 2 cats and a dog, thought better of it. This bed looks very nice just like in the picture. It wasn't difficult to put together alone. One of the steps in the directions was incorrect as I questioned where to screw in the middle slat legs. Otherwise, the steps were easy to follow and was completed in about 20-30 minutes.
Careful Consumer from North Hollywood, CA– Verified Buyer
Good buy! It wasn't easy, but I was able to assemble it by myself. Just stack books under whatever sides you are connecting & you'll be fine while screwing in the bolts. Some of the holes don't match-up exactly when attaching the slats. Don't worry. Just get a long screw driver, and poke it through the holes you are trying to line up, and then once they are, put in the bolts. The bed offers lots of support. I even put my box spring on top of the slats for extra support and height. The bed looks more black than brown, in the pic for the espresso, but it's def. dark brown, so I just painted it black before assembling. Affordable & quality!.