Bello 62" TV Stand

THIS TV STAND WILL HOLD ALL OF THE ITEMS THAT I CAN PUT ON IT AND LOOK GOOD DOING IT

You'll never go wrong with a Bell'o TV stand. Top quality and easy assembly. We used this one for our new 65" TV and it looks fantastic.

Except for the directions, which were hard to follow, we are very pleased with the appearance and quality of the stand.

Just what I was looking for!

We purchased the BellO 2126 model from Wayfair after several attempts using other vendors with lower prices. [...].Unlike the rocket scientists, race car designers, etc, I found the instructions to be sufficient to put this together without any re-dos or glitches. It took myself and our 13 year old daughter a little less than 45 minutes to put together. All of the support braces were clearly marked. The only ambiguity was with the length of the respective screws used to fasten the stand, and that was easy, after all 14mm is shorter than 18mm. We deviated from the instructions only at the end; we placed the bottom shelf in first, then the middle and finally the top. That made more sense to me, giving us more space to maneuver that bottom shelf without having the middle one in place.The stand itself is nice enough cosmetically. It came in good condition, everything fit together well. The cherry wood veneer is rather plain, but cherry usually has little grain, and a 2 inch face doesn't allow much of that to be seen. Our 65 inch plasma looks very nice on the stand. As another person posted, there isn't a lot of room for a center speaker on the middle shelf, but we did barely manage to get ours in place; (it is a modest center channel speaker.)[...] With respect to the BellO TV stand, this model is a nice product, the instructions sufficed to make assembly easy, it is sturdy and has a pleasant design. We would purchase another BellO product from TVStands.com.

Bought this table for my new 46" Panasonic plasma tv, which looks great on it. Probably best put together by two people, but I took my time and put it together myself in about an hour and a half. I like the design but while there is plenty of space for several components I think the shelves could have been a little deeper as there should be a little more room for the component wires in back.

Well constructed, quality piece of furniture.

It has a nice cherry veneer on it, but I found that there was potential in the grain for a better finish and I wanted to match existing furniture. It wasn't hard to sand off the old finish and apply a different stain to the wood. The only design element I'd consider changing is the height of the shelf. It takes some positioning to get tall DVDs and box sets onto that bottom shelf area.

Assembly instructions need work. I am a graduate engineer and I had a hard time following the instructions. If they can't write descriptively then actual pictures of the assembly would be helpful. It is extremely easy to assemble the braces in the wrong position resulting in having to disassemble and start over 1/4 way through. The drawings are not clear until you have already done the assembly. This is a common problem with instruction sheets. They are written by people who have done the assembly many times and are are not tested against first time users. BTW I also build race cars so I am really used to complicated assembly procedures.