Home Improvement Home Theater Mounts & Screens Flat Panel TV Mounts

All TV Mounts

  Style:

Tilt Wall Mount

 
  clear all

Featured Reviews
<strong>Peerless</strong> SmartMount Universal Tilt Mount 32"- 50" Screens Peerless
Peerless SmartMount Universal Tilt Mount 32"- 50" Screens

 4 stars

My Philips 32" LCD was 21½ inches tall, and I had 22½" above a closet door to fit it in my small bedroom. I spent about half a day measuring and calculating the exact spot to bore the holes for the rack. After installing the rack, I mounted the TV onto it, and it cleared the ceiling and the top of the door by a half inch each. BUT, after putting the TV at the proper angle and tightening all the set-screws etc., the TV was 1/4" too low and the top of the door hit it when opened, and there was about a 1" gap between the top of the TV and the ceiling. I took the whole thing down, plugged the holes that I had made, drilled new holes about a half inch higher, and put it up again. That worked just fine, EXCEPT THAT after a few minutes in that position the TV again came down about 1/4" or so, and the door scraped the bottom of the TV. I THEN DISCOVERED WHAT TEH PROBLEM WAS: The top bolt HOLES attaching the TV to the mount were OBLONG rather than round, and (following the instructions!) I had been careful not to over-tighten the bolts), but obviously I had not tightened them sufficiently to keep the TV from moving from the top of those holes to the bottom, so the TV was moving down on the mount. What I had to do (rather than take it all down again) was to use a very short screwdriver, have someone lift the TV so that the bolts were at the TOP of the oblong holes, and then tighten those bolts as much as I could with that short screwdriver, and that did it! This is why my principal negative comment about the mount was that these holes were OBLING rather than round. The only other problem I had was with the spacers which came with the unit. There were two sizes, but neither size fitted the 6MM bolts which my TV called for. (I needed the spacers, so I managed to drilled out the holes in the smaller ones to fit my bolts. If I hadn't done this, I would not have been able to tighten those bolts even with the short screw driver.) Otherwise the mount was PERFECT for my situation, and it is working perfectly since then. Many thanks, James B. Songy Lockport, LA 70374"..."  Read more
- Jim in Lockport, LA 70374

<strong>OmniMount</strong> Large Flat Panel Tilting Wall Mount (Flat panels up to 63") OmniMount
OmniMount Large Flat Panel Tilting Wall Mount (Flat panels up to 63")

 4 stars

Fundamentally, this mount is excellent for wall-mounting the new generation of very large Flat Panel TV's - I'm using it with a new Pioneer PDP-6071 60" Plasma, which weighs approx. 115 lbs. The mount comes with a reference chart for various makes/models to identify the proper screws for attaching the mounting arms to your TV (it comes with all the screws for all the makes/models), as well as extension rails and larger mounting arms to accommodate the real jumbo jets up to 72". The mounting plate itself is completely open in the back to accommodate wiring, and the mounting arms have locakable cams to secure your Flat Panel to the mounting plate...All in all, a very well-designed and solid mount for these new super-sized Flat Panels. My only minor complaint is that when I attached the extension rails, one of them was not perfectly straight, even though there was no apparent damage to the shipping box. It didn't affect the mounting, but if it were off only a bit more, it would have."..."  Read more
- AST in Calabasas, CA

<strong>Peerless</strong> SmartMount Universal Tilt Mount 10" - 37" Screens Peerless
Peerless SmartMount Universal Tilt Mount 10" - 37" Screens

 4 stars

This is my 12th wall mounted flat panel in my modest 1500 sq ft home. OK, I'm a little HDTV OCD lol. Anyway, not my first mount and this was for a 32" LG LED TV for the dining room. Was going up high on the wall so needed the full 15 degrees tilt which this has. Mounting to the wall was easy. Plenty of slotted holes in the mount and I used the included lag screws to anchor to a stud. The parts that go to the TV are never that simple and this mount was no different. There were lots of screws spacers washers etc included but the ones that came with the mount were a little shorter than my liking - would have only been 3 to 4 threads of engagement to the TV - so I used the LG screws that the base was mounted with. Which of course I did not need the base. Those screws were long enough IMO so onward to mounting. I put the mounts low on the TV so the bottom of the TV would not tilt into the wall. Plenty of slotted holes to do this in the mount. I like the locking levers although they do get in the way of the mount and the TV. Just adjust them out of the way. Moral of that story is dry fit everything on the dining room table first then go to the wall with it. Summary - very good quality and engineering for the price."..."  Read more
- OCDave in Lone Star State

<strong>Level Mount</strong> Fixed/Tilt Mount  With Extension Arms For Flat Screen TV's (34" - 65" Screens) Level Mount
Level Mount Fixed/Tilt Mount With Extension Arms For Flat Screen TV's (34" - 65" Screens)

 5 stars

this tv mount is great , I used this mount for 42" tv , it holds up the TV very well , all the screws were included with it , easy to install and made of strong good quality metal , the price is perfect plus the free shipping , Wayfair is the best for everything , will buy more for other room tv ."..."  Read more
- Fatima Anwar in OCALA, FL

All TV Mounts

Related Products
Adjustable tilt wall mount with Universal hole pattern ...
This is a solid mount, the wall plate ...
The Pinpoint Mounts VM210 is a universal wall ...
Narrow
within All TV Mounts
 Your Search
  Mount Type
  Wall Mount (124)
 Desktop Mount
  Ceiling Mount (2)
 Corner Mount
 Flipdown Mount
 Floor Stand Mount
  Pole Mount (1)
  Component Shelving Included
  Motorized
  Price Range
$9$599

 to    GO
SPONSORED CONTENT

ServerT:0.3291802406311