AV Mounts, Arms and Hardware

Attached a Dell U2711 monitor on it and it holds it without any problems. May want to check the tilting joints as they were not adjusted prior to shipment. I attempte to place the mount with the monitor on the installed wall plate, but soon found out my monitor was tilting already. When you are doing this as a one-man install job this hiccup makes it a little difficult. I had to remove the monitor and mount from the wall plate and tighten the tilting joint myself. On the paperwork it says that all the joint screws are tensioned to the correct proportions; however I would still check it before installing the arm. Additionally, the clips included for the cable management are ill-conceived. They do not lock into place on any of the Bretford arms that I have owned (I have three of them). The clips are meant to attach the cables of the monitor to the underside of the swing arm where there is a little slit to insert the clips into. Despite these little annoyances I would still recommend this product. Hey a bought 3 of them so they couldn't be that bad. Just figure out your placement first as the height adjustment of the arm is very limited."..."  Read more

I first purchased the single arm model, unfortunately it did not extend my monitor far enough for my liking. Wayfair took it back, no problem, and exchanged it for the two arm model. The build quality is excellent a real quality product that I would recomend to anyone looking for the best"..."  Read more